pdp
true
2017.14.1.0.7.0

FSHSAVE67

jcpenney.com | GE® 1/2 HP Continuous-Feed Garbage Disposer - Non-Corded

GE® 1/2 HP Continuous-Feed Garbage Disposer - Non-Corded

Model # GFC530V
web ID: 8770107
both
PRODUCT DESCRIPTION
Use the trash less and get rid of your food waste in a snap with this continuous-feed garbage disposer Its angled fin pumps water down more force to help clear drains and reduce clogs. It quickly hits the max speed and high torque so foods are less likely to jam or clog.
 
  • EZ Mount installation means fewer parts and steps
  • over 2800 RPM for a fast, fine grind
  • 1/2 HP motor
  • 31-oz. grind chamber capacity
  • dishwasher drain connector
  • manual reset overload protector
  • stainless steel grinding components
  • cold-rolled carbon steel armature shaft material
  • SplashGuard
  • wall switch with sink stopper
  • stainless steel sink flange
  • 2-level precutter

Product Specifications

DIMENSIONS
Depth (in.) 7 3/4 Inch Width (in.) 7 3/4 Inch
Height (in.) 13 7/16 Inch grind champer capacity (oz) Extra-large
Length (in.) 7 3/4 Inch
DETAILS
Amperage (amps) 4.5a Voltage (volts) 120v
Appliance Series Not Applicable disposer feed Continuous
Appliance Types Disposals grind chamber type Stainless Steel
Drain hose connection Yes grind stage 1 Stage
Energy Consumption (kWh/year) Not Rated grinding speed (RPM) 2800
Features Septic System Use, Continuous Feed noise insulation Yes
Finish Black safe for septic system Yes
Horsepower 1/2 Hp
WARRANTY/CERTIFICATIONS
Certifications and Listings Ul Listed Labor Warranty Limited 1 Year Entire Appliance
JCPenney Exclusive No Parts Warranty Limited 1 Year Entire Appliance, Ltd 3 Yr Fnctnl Part
Rated 5 out of 5 by from Stainless steel neck and chamber Was easy to install with locking ring. Also runs very quiet. I researched disposers and found this one has stainless for all wet metal parts. As my last disposer corroded out, this was an important feature.
Date published: 2017-05-20
Rated 5 out of 5 by from Absolutely love it!! This disposal is so quiet and fast , differently recommend!!!
Date published: 2017-08-03
Rated 5 out of 5 by from Very Quiet Bought this specific model to replace an older GE disposal. A lot quieter than the previous model. Works extremely well.
Date published: 2017-03-19
Rated 5 out of 5 by from Quiet and smooth operation! Other than a little difficulty mounting up to sink. I love the easy of which it can be replaced should it ever need to.
Date published: 2017-03-02
Rated 5 out of 5 by from works well GE Disposall works well. Relatively quiet. Easy to install.
Date published: 2017-03-11
Rated 4 out of 5 by from Quiet I bought this to replace a 1/3hp InSinkErator Badger 1. The Badger was badly corroded from our very hard water. I installed the GE in a Corian molded sink and it's extremely quiet. I think a stainless sink would amplify the sound more than the Corian. I chose this model because it has a stainless grinding chamber instead of cast iron. I expect it to withstand the onslaught of hard water better than cast iron. On the down side, the rubber baffle does not allow the water to drain quickly. The inside diameter of the collar/flange for the discharge elbow was too big for the elbow and I had a small leak where the elbow contacts the disposer. I used my old elbow which fit perfectly with no leaks. Also, you'll want to lube the support ring, mounting ring and cushion mount so you can rotate/tighten these components more easily. I tightened the support ring on each of the two days following the initial installation. I think the plumbers putty compressed with time.
Date published: 2015-01-04
Rated 3 out of 5 by from Adequate, nothing exciting 1. noise--louder than expected 2. easy to install overall, the nut holding down the bottom plate is difficult to access--too small of an opening around the nut. 3. smaller inlet/throat than the previously installed model could use the previous strainer 4. different mounting--had to remove previous mounting brackets--which I thought were industry standard--at least I have seen the previous mounting brackets on all of the previous disposals that I have worked on. 5. the hole in the cover plate that holds the discharge tube on is too large or the flange on the discharge tube is too small--thus the discharge tube could gap and allow leakage. Added a plastic compression gasket which centered the metal opening and will keep it from leaking. This forced me to install longer bolts, since the ones supplied were not intended to have a gasket under the metal plate. 6. nice size, give a lot more room under the sink 7. space under the bottom plate for the electrical connections is not very generous overall good enough for the price I paid for it.
Date published: 2014-02-03
Rated 5 out of 5 by from retro install a plus purchased to replace previous unit that came with home. pleased that GE has kept physical specs same over the years so install went very smoothly with same under sink hook ups.
Date published: 2017-04-22
  • y_2017, m_8, d_18, h_14
  • bvseo_bulk, prod_bvrr, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_340
  • loc_en_US, sid_pp5006291679, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_jcpenney
  • bvseo_sdk, java_sdk, bvseo-2.2.0.4
  • getReviews, method:CLOUD, 28ms
  • REVIEWS, PRODUCT
  • bvseo_sdk, java_sdk, bvseo-2.2.0.4
  • getContent, method:CLOUD, 15ms
  • QUESTIONS, PRODUCT
  • bvseo-msg: The resource to the URL or file is currently unavailable.;
Protection Plans
  • CHECK ITEM AVAILABILITY
attention
attention
selectedSkuId
attention
This item is not available for international shipping.
  • ADD TO BAG
Questions?
1-844-JCP-APPL
(1-844-527-2775)
see stores with major
appliance display
Appliance haul away and/or moving services are available for purchase. see details
4.38 340